Using the PPP Outgoing Connection Wizard,
enter the following information about the devices that can be used
to establish an outgoing PPP link:
From the list of available devices, select each device that will be
available for use in establishing a PPP link, and click on
Add >> to add it to the list. To remove a device from the list of
selected devices, select it from the list and click on << Remove.
Select the type of flow control to be used: Hardware
(RTS/CTS), Software (XON/XOFF), or
Flow control is not selectable for synchronous
mode ISDN. For other types of devices, you should usually choose
Multilink maximum links
Select the maximum number of devices that can be used for a multilink
PPP connection to a remote host. This number cannot be greater
than the number of devices that you select as being available to the link.
If the service provider does not support multilink PPP or you
want to disable multilink PPP, set the number of links to 1.
If the number of links is greater than 1 and the service provider
does not support multilink PPP, it should still be possible
to negotiate the use of an ordinary unilink PPP connection.
For ISDN devices which support several channels, select
the devices corresponding to the channels that you
want to make available for a multilink PPP connection.
© 2004 The SCO Group, Inc. All rights reserved.
UnixWare 7 Release 7.1.4 - 22 April 2004