(gdb) Break Commands

Info Catalog

(gdb) Conditions

(gdb) Breakpoints

(gdb) Breakpoint Menus

 
 Breakpoint command lists
 ------------------------
 
    You can give any breakpoint (or watchpoint or catchpoint) a series of
 commands to execute when your program stops due to that breakpoint.  For
 example, you might want to print the values of certain expressions, or
 enable other breakpoints.
 
 `commands [BNUM]'
 `... COMMAND-LIST ...'
 `end'
      Specify a list of commands for breakpoint number BNUM.  The
      commands themselves appear on the following lines.  Type a line
      containing just `end' to terminate the commands.
 
      To remove all commands from a breakpoint, type `commands' and
      follow it immediately with `end'; that is, give no commands.
 
      With no BNUM argument, `commands' refers to the last breakpoint,
      watchpoint, or catchpoint set (not to the breakpoint most recently
      encountered).
 
    Pressing <RET> as a means of repeating the last GDB command is
 disabled within a COMMAND-LIST.
 
    You can use breakpoint commands to start your program up again.
 Simply use the `continue' command, or `step', or any other command that
 resumes execution.
 
    Any other commands in the command list, after a command that resumes
 execution, are ignored.  This is because any time you resume execution
 (even with a simple `next' or `step'), you may encounter another
 breakpoint--which could have its own command list, leading to
 ambiguities about which list to execute.
 
    If the first command you specify in a command list is `silent', the
 usual message about stopping at a breakpoint is not printed.  This may
 be desirable for breakpoints that are to print a specific message and
 then continue.  If none of the remaining commands print anything, you
 see no sign that the breakpoint was reached.  `silent' is meaningful
 only at the beginning of a breakpoint command list.
 
    The commands `echo', `output', and `printf' allow you to print
 precisely controlled output, and are often useful in silent
 breakpoints.   Commands for controlled output Output.
 
    For example, here is how you could use breakpoint commands to print
 the value of `x' at entry to `foo' whenever `x' is positive.
 
      break foo if x>0
      commands
      silent
      printf "x is %d\n",x
      cont
      end
 
    One application for breakpoint commands is to compensate for one bug
 so you can test for another.  Put a breakpoint just after the erroneous
 line of code, give it a condition to detect the case in which something
 erroneous has been done, and give it commands to assign correct values
 to any variables that need them.  End with the `continue' command so
 that your program does not stop, and start with the `silent' command so
 that no output is produced.  Here is an example:
 
      break 403
      commands
      silent
      set x = y + 4
      cont
      end
 

Info Catalog

(gdb) Conditions

(gdb) Breakpoints

(gdb) Breakpoint Menus